Home Enhancer Model (HEM) Setup Instructions

A solar thermal collector with reflective surface, connected to a water tank and a small pump, set up on a flat surface for a demonstration or experiment.
A white, rectangular device with a black handle on top, two elongated vents on the front, and a printed set of operating instructions on the front panel.
A solar thermal collector with a black heat sink and a small fan, connected to electrical wires and mounted on a white frame with reflective surface.

Put the cooler on the glass base. The power cord is wrapped around the fan to keep it out of the way during setup.

Close-up of laboratory equipment on a laboratory bench, including a white device with screws, a clear plastic component, a white cable, and a black and red tool or battery pack.
Close-up of a white laboratory or electronic device with a clear plastic shield, screws, and wires.
Close-up of a scientific instrument with a clear plastic cover, a white power adapter, a black cooling fan on top, and wires connected to the device, situated on a white surface.
A white electronic device labeled 'FAN' with a power cord, a switch, and ventilation slots on a light-colored surface against a plain wall.
A homemade solar water heater setup with a glass panel, a black water pump, and a light bulb in a cardboard box, connected with wires and tubes.
Laboratory setup with a clear acrylic enclosure containing a small fan, copper coil, and tubing connected to a power supply, with a cardboard box holding a glass bulb and additional wires.

When you unpack your Enhancer these are the parts you’ll have minus the flat head screwdriver.

Notice on the front of the power box are the instructions on how to get on and off of the Enhancer.

Put the brass screws in the clamp block and rest them in the holes.

Line up the cooler opening to the black line on the clamp block. The copper should be over the aluminum foil.

It should look like this.

Thread the fan cord through the handle to keep it out of the way. Plug the cooler fan into the back of the power box where it says “fan”.

The power cord plug-in is right underneath the fan cord plug-in. The power cord can be plugged into a 3 prong outlet or power strip.

Plug the bulb into the cooler where is says “bulb”.

Plug the white clamp block wire into the Right plug-in on the power box.

Plug-in the white wire on the foil block into the Left plug side of the power box. There are 2 holes and it does not matter which one you use.

When finished it should look like this.

You are now ready to start Enhancing!